Cropping Plates
At Highland, we want to give you the best coating finish possible. As our service complements your product then we need to work together at the design stage. Considering important information like cropping plates prior to fabrication will give you the best finish on your galvanizing and powder-coating.
Crops or snipes in locations where air, water and zinc would normally be trapped allows the zinc to run freely, leaving your project with a superior quality finish. If you are at all unsure about any aspect of a design, one of our technical experts would be more than happy to discuss this with you.
After all it is much easier and less expensive to change a drawing than to alter material after fabrication!
Should you wish for any further information please do not hesitate to contact one of our experts.